Need help?Do you have a question about the Pierce HUSKY 12 GPM and is the answer not in the manual?
General| Brand | Pierce |
|---|---|
| Model | HUSKY 12 GPM |
| Category | Irrigation System |
| Language | English |
Explains the manual's intent for operation and maintenance of the Husky 12 Proportioning System.
Details the manual's coverage of safety, general information, operation, maintenance, and appendices.
Provides steps for contacting dealers and Pierce Manufacturing for support.
Introduces manual purpose, warns of danger, and explains safety signal words and symbols.
Provides a list of terms and their definitions used in the manual.
Details the technical specifications of the Husky 12 Foam Proportioning System.
Identifies and describes the function of the system's key components.
Describes the flush mode and compatible foam concentrates for the system.
Details the hydraulic gear pump and oil filter.
Explains the hydraulic oil reservoir and cooler components.
Describes the hydraulic manifold and the foam supply system.
Details the foam supply valve and the foam concentrate pump.
A 2-way ball valve that directs foam for injection or tank filling.
Describes the strainer/connector unit and its function in filtering foam concentrate.
Covers pick-up hose, foam check valve, and water supply system.
Details manifold drains and the in-line water check valve.
Measures water flow to control foam injection rate.
Details the control head/display module that programs and controls the foam system.
Explains how to operate the foam system for various scenarios.
Guides for using Class A foam from onboard tank and drafting.
Guides for using Class B foam from onboard tank and drafting.
Explains how to select the foam source (on-board tank or drafting).
Describes the flush mode and provides general flushing information.
Details the priming system and control head display in prime mode.
Provides procedures for filling the foam tank using dome or pick-up hose.
Describes the manual override for activating the foam pump without the flowmeter.
Details the procedure for draining the foam tank using the system interface.
Introduces maintenance and testing after system repairs.
Instructions on how to check the system's software version.
Information on system diagnostics, including inputs and outputs.
Details the commanded values, actual values, and circuit status of system outputs.
Overview of mode activation and sub-categories for setup, calibration, and maintenance.
Allows adjustment of flush timer, auto start, units, language, and backlight.
Provides procedures for calibrating system components like flowmeter and pump.
Details how to reset maintenance reminders and timers.
Addresses common operational difficulties and their solutions.
Recommends periodic operation to ensure system functionality and concentrate circulation.
Covers inspection of hardware, wiring, lines, and hydraulic tank.
Provides checks and services to keep equipment in good operating condition.
Covers checks for hydraulic oil, foam tank level, hydraulic system, and plumbing.
Details weekly cleaning and inspection of the water strainer.
Details quarterly cleaning and inspection of the foam strainer.
Obtains and compares hydraulic oil samples to check for degradation.
Discusses oil characteristics and lists specific recommended oil types.
Recommends oil analysis and provides guidelines for oil changes.
Shows the schematic diagram of the Husky 12 hydraulic system.
Details wiring harness connections for different system areas.
Provides a schematic diagram of the entire Husky 12 foam system.
To Next Page
