AVAILABLE WIRING
(
PCHKD
)
• Step 1: Bolt the cattle siren to a
at surface such as a headache
rack or under the hood using (2)
1/4” bolts or (2) #12 self tapping
screws.
• Step 2: Plug the male end
to the female end of the
connectors.
• Step 3: Mount the On-Off
switch in the truck’s cab.
• Step 4: Mount breaker near the
battery using #10 screws.
• Step 5: Run black wire to
negative battery terminal.
• Step 6A: Run the red wire to the
toggle switch and connect with
push on connectors.
• Step 6B: Run the red wire from
the switch to the breaker with
the small terminals.
• Step 6C: Run the red wire from
the breaker to the positive
battery terminal, with the large
terminal.
• NOTE: For installation with
existing wiring, simply cut off
connector and splice in your
wiring.
• (2) 3/8” Ring Terminal
• (2) 1/4” Push-On Terminal
• (1) 2-Pin Connector
• (1) On-Off Switch
• (2) #10 Ring Terminal
• (1) 30 amp Breaker
• (1) 16 gauge Wire, 15’ long with
Connector, Red and Black
INSTALLATION
HEAVY DUTY CATTLE SIREN
(
PS093
)
3
To Next Page
Loading...