EasyManua.ls Logo

PIKO 35040 - Page 9

PIKO 35040
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
35040
R/C Loco Receiver, 3A,
with Pocket Remote
1. General information
Thank you for purchasing the PIKO R/C system for radio operation.
of garden railway models.
Please read these operating instructions carefully in order to be
able to use all the functions of this device. It is essential that you
observe the following safety and warning instructions to ensure
trouble-free and safe operation of your model.
With this set you can retrot an analogue locomotive for radio
operation. With the main circuit board (receiver), a switch plate
and a transmitter (remote control), you receive all the components
for radio operation. It is possible to supply the system with battery
voltage* or permanent track voltage. In addition, two switching fun-
ctions / sound functions (depending on the locomotive equipment)
are switchable.
*Batteries or battery holders are not included in the set.
2. Safety & warning information
The remote control system has been designed and approved exclu-
sively for the control of RC models. PIKO Modellbau assumes no
liability in the event of any other use. Remote-controlled models are
not toys and only suitable for model railroaders aged 14 and over.
The construction and operation of such models requires special
knowledge, technical care, technical understanding and careful,
safety-conscious behaviour. Errors during assembly or operation
can cause considerable damage to property and personal injury. As
manufacturers and sellers, we are unable to monitor the operation
of our products. Therefore we do not assume any liability. Technical
defects of an electrical or mechanical nature can lead to the
unexpected starting of a motor, which can seriously injure not only
you! Even an operation of the receiver system without activated
35040-90-7000.indd 9 19.08.19 08:43

Related product manuals