12
HOW TO USE
1- Before you get your child on the vehicle, the seat is adjusted according to child’s age and size, by pressing the nails next to the seat. After child sits on the vehicle’s seat,
the key is mounted to the ignition socket which is located at the front by pressing until the light is on. The motion which was designed as a gearshift and which is located in
the middle, provides forwards and backwards movement.
2- For the rst movement of the vehicle, it is advised that you keep the handle which was designed as a gearshift in front. Your vehicle is ready for movement. In order your
vehicle to move, the vehicle moves by pressing on the movement pedal which is located at the right side of the foot-setting place. The steering wheel should be in straight
position.
3- For break, you should pull your foot from the gas pedal. The vehicle stops thanks to electronic braking system.
4- It is required for a child not to use the vehicle by tampering with the gear levers sharply while the vehicle is moving and by continuing pressing the accelerator when the
vehicle crushes into an obstacle. Using the vehicle in this way might cause the battery to run out quickly, drain the battery life and damage the vehicle’s cables and motor.
There is an integrated thermal fuse (heat-sensitive) on the battery in order to protect the battery from overheating in consequence of cable overstraining while driving. This
fuse switches the circuit o because of the overheating of the cables and equipment. You might realize that this fuse blew o when the vehicle does not start no matter what.
Wait for some time (5-20 seconds, this duration might change depending on the air temperature). At the end of this duration, the fuse automatically switches on the circuit
and the vehicle starts.
5- Instructions for removing vehicle’s battery is given on page 28.
HOW TO USE
Accelerator Gearbox Air Horn Charger Contact Forward / Back Adjustable Seat
forward
backwards
To Next Page
Loading...