PIMAX Crystal - 5. Headset Cleaning and Care; Foam Facial Interface Cleaning; Headset Lens Cleaning; Cleaning Other Components

20
6. Supervision
5. How to Clean and Care for Your
Pimax Headset
In the standalone mode: check the certification and supervision information of the product in the region of sale in the main menu
"Settings → General → About → Supervision" after the headset is turned on.
 Cleaning and Caring for the Foam Facial Interface
Using a clean alchohol wipe, or a clean microfiber cloth dipped in a small amount of 75% alcohol solution, gently wipe the
surface and surrounding areas in contact with the skin until the surface is slightly wet. Allow to dry for 5 minutes or until
completely dry before use.
CAUTION READ CAREFULLY
The foam facial interface will begin to exhibit signs of wear and tear after repeated cleaning and disinfection. Hand washing or
machine washing is not recommended as it will accelerate the wear and tear. It is recommended to replace the foam occasionally
as appropriate.
Leather PU foam: discoloration, stickiness on the surface, and reduced comfort on the face
Cloth foam: discoloration, surface fuzzing, texture softening, glasses wearing users may have an increased
chance of contact with the HMD lenses.
2. Lens care
During use or storage, please be careful and prevent hard objects from touching the lens. Hard objects may damage the lenses
Use a clean microfiber cloth, like those used to clean eyeglasses, to gently clean the lenses with a small amount of clean water
or dry. Do not rub the lenses in a circular motion. Starting from the center of the lenses push the cloth out to the edge of the
lenses to reduce the risk of scratches.
CAUTION READ CAREFULLY
Do not use alcohol to clean the lenses, as it may cause damage to the lens coatings ) .
3 . Headset (e xcluding l ens , Sponge m as k), Controllers and
accessories cleaning
W ipe the surface of the product gently with a sterilized wet towel ( which can contain alcohol ) or a micro - fiber dry cloth dipped in
a small amount of 75% alcohol until the surface is wet and kept for more than 5 minutes, and then dry the surface of the product
with a micro - fiber dry cloth.
CAUTION READ CAREFULLY
P lease avoid water entering the product body during cleaning.