3. Do not use chemically descaled water or any other liquids for refilling.
HOW TO FILL IN WATER
1. Unplug the iron from the wall outlet.
2. Switch the Steam button to the “0” position and Temperature Control Dial to the
MIN position.
3. Hold the iron handle, tilt the iron and fill in water through water inlet slowly. Fill
Up to the max level of the water tank.
IMPORTANT:
Remove all the water from the water tank and dry the product after use.
SETTING THE TEMPERATURE
1. Insert the plug in the wall socket and stand the iron upright.
2. Turn the temperature control dial to the correct temperature.
3. The correct temperature will be reached when the pilot light has turned off. The
pilot light will be on and off from time to time indicating that the selected
temperature is being maintained.
STEAM IRON
This function can be used only at higher ironing temperature.
● ● For moderate steam
● ● ● Or Max for maximum steam
1. Fill water into the iron as described above.
2. Stand the iron on its rear side.
3. Connect the iron to a suitable mains supply outlet.
4. Turn the temperature control dial to the “● ●”, “● ● ●” or MAX setting.
5. The pilot light turns off when the required temperature is reached. The iron is
ready for use.
6. Switch the steam button to the required position, steam starts coming out from
the holes in the sole plate.
Note: With conventional steam ironing, water may leak from the sole plate if too low
a temperature has been selected. If this happens, turn the temperature control dial
to the correct position, steam will recommence as soon as the appropriate,
temperature has been reached.
DRY IRONING
1. Turn temperature control dial to MIN position, with the steam button being in
To Next Page
Loading...