4 ZERO/FULL WEIGHT LEARNING METHODS
1 Press the power key to start up the scale, until in weighing mode.
2 Input number [1377].
3 Destroy the sealing (chapter 3.1) and press the green adjustable switch.
4 Please make sure the platter is in horizontal and there is no object on platter.
5 Input number [2400128], press [CHG] key to confirm. It will set the range as 15kg.
Input number [2400192], press [CHG] key to confirm. It will set the range as 30kg.
6 Press the key [M1] continuously for two times, at this time you can hear a long sound
‘beep’ which means the zero weight learning is successful. The weight column will
display 0.000.
7 Put the full weight on the platter.
8 Press the key [M2] continuously for two times, at this time you can hear a long sound
‘beep’ which means full weight learning is successful. The weight column will display
the full weight 15.000 or 30.000 (depends on the setting on step 5 above).
9 Put any weight on the platter to check whether the zero/full learning is successful or
not.
10 Restart the machine to exit factory mode
To Next Page
Loading...