Pinnacle IKONIC DSS003 - User Manual

On the back of the lock you will see screw buttons which relate to the push buttons on the front of the lock.
To set the numbers for your code, depress and turn the screw button relating to the desired digit 180 degrees so that the
dot is facing inwards (towards the F). If you wish to take a number out of the code, turn the screw button so that the dot
is facing outwards (towards G).
IMPORTANT NOTE: Be sure to check the code on the lock works before tting/re-tting the lock and closing the door.
When the lock is coded and you would like to change the code, be sure to turn all screw buttons from the current code in
a clockwise direction 180 degrees (all dots facing outwards) to cancel the original code then set your new one.
Each and every time you wish to unlock your door you must start by pushing the ‘C’ button.
The snib on the internal block can be used to keep the latch open. Simply turn the lever handle to withdraw the
latch and push the snib to the opposite side.
See instructions on the snib that performs this function in the next section. Also check that the latch moves freely by pressing the end and by turning with the spindle.
ALL NUMBERS OFF
ALL NUMBERS ON
Applying the template:
1) Tape the template to the door. Make sure that you fold it along the appropriate line.
The back set on the included latch is 60mm.
2) Mark and drill the two 10mm holes and one 13mm hole.
3) Mark a central point on the “center line of latch” on the door edge.
4) Drill a 25mm hole x 85mm deep.
5) Insert the latch into the hole and draw around the face plate.
6) Remove the latch and cut a 3mm rebate so that the face plate will t ush with the door.
7) Secure the latch with the wood screws.
Please fasten all screws by hand. Do not use an
electric screwdriver or drill as over tightening is
not recommended.
You will need untighten the screw in the large hole on the
back of your digital lock to change the vertical handle to a
horizontal left or right hand opening.
Please Note:
13mm
&10mm
drill bits

Summary

Safety and Preparation

Safety Tip

Wear protective gloves and eyewear during assembly and installation.

Installation Tools Required

Lists the necessary tools for installing the digital lock.

Before Installation Checklist

Verify parts, set codes, check handle/latch movement, and door suitability.

Setting and Changing the Code

Code Setting Instructions

Details on how to set or change the digital lock's access code using screw buttons.

Latch Hold Back Function

Explains using the snib on the internal block to keep the latch open.

Installation Steps

Applying the Template

Instructions for taping the template to the door and marking holes.

Fitting the Spring Loaded Spindle

Guidance on installing the spring-loaded spindle into the latch.

Fixing the Lock

Steps for securing the lock onto the door, including bolt length and seals.

Fitting the Striker Plate

Instructions for positioning and securing the striker plate to the door frame.

Additional Information

Handy Hint

Tip on reversing the lever handle for better door frame clearance.

Warranty Conditions

Details on product warranty terms, claims, and coverage.

Pinnacle IKONIC DSS003 Specifications

General

Brand	Pinnacle
Model	IKONIC DSS003
Category	Locks
Language	English