STEP 9
Use the Allen wrench and M6*14
hexagonal screws to fasten.
STEP 10
Installation of the main parts are
finished.
STEP 11
Use hand to move the metal parts
(with hole) at the right and left sides
to the outside, connect the holes
with the resistance bands.
STEP 12
Please use allen wrench to lock this
cup holder into the tube by Cross
recessed screw.
Installation completed. Set the entire
unit back upright. Plug one end of
the power cord into the back of the
unit’s casing, next to the power
switch.
To Next Page
Loading...