Need help?Do you have a question about the PIONEER DJ OPUS-QUAD and is the answer not in the manual?
Turn on the OPUS-QUAD and press [SHORT CUT(UTILITY)] for over 1 sec to open the UTILITY screen.
Scroll to [General] in the UTILITY screen to view the firmware version at the bottom.
Unzip the downloaded [OPUSQUADv***.zip] file to find the update file.
Copy the unzipped update file to the root directory of a FAT/FAT32 USB storage device.
Power off unit, then power on while pressing [BEAT SYNC] and [MASTER] buttons simultaneously.
Insert the USB storage device with the update file into the USB 1 port.
The update starts automatically; monitor the Progress Bar and version display.
Turn off the power after the completion message, disconnect USB, and check the firmware version.
General| Channels | 4 |
|---|---|
| Wi-Fi | Yes |
| Bluetooth | Yes |
| Frequency Response | 20 Hz - 20 kHz |
| Supported Audio File Formats | MP3, AAC, WAV, AIFF, FLAC |
| Bit Depth | 16-bit, 24-bit |
| Type | DJ System |
| USB Ports | 3 x USB Type-A, 1 x USB Type-B |
| Display | Yes, Touchscreen |
| Weight | 13.2 kg |
| Inputs | XLR, RCA, 1/4-inch |
| Outputs | XLR, RCA, 1/4-inch |
| Sampling Rate | 44.1 kHz, 48 kHz |
| Media Players | USB |
| Software | rekordbox, Serato DJ Pro (support planned) |
| Connectivity | USB, Wi-Fi, Bluetooth |
| Effects | Beat FX, Sound Color FX |
| Signal-to-Noise Ratio | 114 dB |
To Next Page