Need help?Do you have a question about the Pioneer PRS-A700 and is the answer not in the manual?
When the unit does not operate properly, contact your dealer or the nearest authorized PIONEER Service Station.
General safety warnings regarding fuse replacement, wet hands, volume, power connections, and liquid contact.
Adjusting gain controls to match car stereo output and amplifier input levels for optimal sound.
Switch for selecting two-channel or four-channel input for the amplifier.
Selecting a cut-off frequency between 40 and 120 Hz for LPF or HPF.
The power indicator lights up when the unit is powered on.
Adjusting the BFC switch to eliminate beats during MW/LW broadcasts.
Selecting Low-Pass Filter (LPF) or High-Pass Filter (HPF) for speaker outputs.
Diagram illustrating the wiring connections for power, input, and speaker outputs.
Instructions for connecting the battery wire, ground wire, and system remote control wire.
Procedures for preparing and connecting speaker wires to the output terminals.
Guidance on connecting speakers and input wires for four-channel, three-channel, and two-channel modes.
Important cautions for installation, including avoiding seats, wiring, liquids, and ensuring ventilation.
Step-by-step guide for physically mounting the amplifier using tapping screws.
To Next Page
General