System Firmware Update Instructions for Pioneer SMARTPHONE
Receivers (SPH-C10BT)
This firmware update (version 8.21) applies only to the following models of Pioneer products sold in the
Singapore, Malaysia, Indonesia, Philippines, Sri Lanka, Vietnam, Thailand, Cambodia, Myanmar and
Laos.
SPH-C10BT
IMPORTANT
Please download and print these firmware update instructions before downloading and installing the
firmware update. It is important that you complete all steps correctly and in the order described below.
Note: If you have any questions, please contact the nearest Pioneer Customer Service at your country.
You can refer to https://sg.pioneercarentertainment.com/service for more information.
In order to perform this update, the following items are needed:
• Pioneer SmartPhone receiver listed above.
• A USB storage device meeting the following requirements.
- 2 GB or larger in capacity, formatted to FAT32
- Blank (should not contain any files)
CAUTION
• DO NOT turn your unit off or eject the USB storage device while the firmware is being updated.
• You can only update the firmware when the vehicle is stopped and the parking brake is engaged.
To Next Page
Need help?
General
