Pioneer XR-A390 User Manual

|
READ INSTRUCTIONS — Ali the safety and
operating instructions should be read before
the product is operated
RETAIN INSTRUCTIONS — The safety and
operating structions shoutd be retained for
future reference,
HEED WARNINGS — Ail warnings on the product
and in the operating instructions should be
adhered to.
FOLLOW INSTRUCTIONS — Ali operating and
use instructions should be tollowed
CLEANING — Unplug this product from the wall
outlet before cleaning. The product should be
cleaned only with a polishing cloth or a soft dry
cloth. Never clean with furniture wax, benzine,
insecticides or other volatile liquids since they
may corrode the cabinet
ATTACHMENTS —- Do not use attachments not
recommended by the product manufacturer as
they may cause hazards
WATER AND MOISTURE — Do not use this
product near water -~ for example, near a
bathtub, wash bowl, kitchen sink, or laundry
tub; in a wet basement; of near a swimming
pool; and the like
| ACCESSORIES — Do not place this product on an
unstable cart, stand, tripod, bracket, or table.
The product may fail, causing serious injury to
a child or adult, and serious damage to the
Use only with 8 cart, stand, tnpod,
or table recommended by the
manufacturer, or sold with the product. Any
mounting of the product should follow the
manufacturer's instructions, and should use a
mounting accessory recommended by the
manufacturer
CART — A product and cart cornbination should be
moved with care, Quick stops, excessive force,
and uneven surfaces may cause the product
and cart combination to overtum.
VENTILATION — Slots and openings in the cabinet
are provided for ventilation and to ensure reliable
operation of the product and to protect it from
overheating, and these openings must not be
blocked or covered. The openings should never
be blocked by placing the product ona bed, sofa,
rug, or other similar surface. This product should
not be placed in a bulft-in installation such as a
bookcase or rack unless proper ventilation is
provided or the manufacturer's instructions have
been adhered to
POWER SOURCES ~~ This product should be
operated anty fromm the type of power source
indicated on the marking label. ff you are not
sure of the type of power supply to your home,
consult your product dealer or local power
company.
LOCATION - The appliance should be installed
in a stable location.
NONUSE PERIODS - The power cord of the
appliance should be unplugged from the
outlet when left unused for a long period of
time.
GROUNDING OR POLARIZATION
e@ ff this product is equipped with a polarized
alternating current line plug f@ plug having one
blade wider than the othe), it will fit nto the outlet
oniy one way. This is 2 safety feature. if you are
unable to insert the plug fully into the outlet, try
reversing the plug. e plug should stil fai! to fit,
contact your electricien to replace your obsolete
outlet. Do not defeat the safety purpose of the
polarized plug.
e@ ff this product :s equipped with a three-wire
grounding type plug, a slug having a third
(grounding) pin, twill only fit into a grounding type
power outlet. This is a safety feature. If you are
unable to insert the plug into the , contact
your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the grounding
type plug.
POWER-CORD PROTECTION — Power-supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to cords
at plugs, convenience receptacles, and the paint
where they exit from the product.
OUTDOOR ANTENNA GROUNDING — If an outside
antenna or cable system is connected to the
product, be sure the antenna or cable systern is
grounded so as to provide some protection against
voltage surges and built-up static charges. Article
810 of the National Electrical Code, ANSI/NFPA
70, provides information with regard to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
focation of antenna-discharge unit, connection to
grounding electrodes, and requirements for the
grounding electrode. See Figure A
LIGHTNING — For added protection for this product
during a lightning storm, or when it is left
unattended and unused for fong periods of time,
unplug it from the wall outlet and disconnect the
antenna or cable system. This will prevent damage
to the product due to fightning and powerine
surges
POWER LINES — An outside antenna system should
not be located in the vicinity of overhead power
fines or other electric light or power circuits, or
where it can fait into such power fines or circuits
When installing an outside antenna system,
extreme care should be taken to keep from
touching such power lines or circuits as contact
with them might be fatal
OVERLOADING — Do not overload wall outlets,
extension cords, or integral convenience
receptacles as this can resuit in a risk of fire of
electric shock
GROUND
CLAMP
A
7
ELECTRIC
[ SERVICE
fo
EQUIPMENT —~—___ TL
—
| Sea
~
IMPORTANT
SAFETY
INSTRUCTIONS
—
OBJECT AND LIQUID ENTRY — Never push
objects of any kind into this product through
openings as they may touch dangerous voltage
points of short-out parts that could result ina
fire of electric shock. Never spil! liquid of any
kind on the product.
SERVICING — Do not attempt to service this
product yourself as opening or removing covers
may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service
personnel
DAMAGE REQUIRING SERVICE — Unplug this
product from the wall outlet and refer servicing
to qualified service personnel under the
following conditions:
@ When the power-supply cerd or plug is
damaged.
@ = Hfliquid has been spilled, or objects have fallen:
into the product,
e if the product has been exposed to rain or
water
@ = ff the product does not operate normaily by
following the operating instructions. Adjust only
those controls that are covered by the operating
instructions as an improper adjustment of other
controls may result in damage and will often
require extensive work by 2 qualified technician
to restore the product to its normal operation,
@ = Hf the product has been dropped or damaged in
any way
@ When the product exhibits a distinct change in
performance — this indicates a nead for service,
REPLACEMENT PARTS — When replacement
parts are required, be sure the service technician
has used replacement parts specified by the
manufacturer or have the same characteristics
as the orginal part. Unauthorized substitutions
may result in fire, electric shock, or other
hazards.
SAFETY CHECK — Upon completion of any service
or repairs to this product, ask the service
technician to perform safety checks to
determine that the product is in proper operating
condition.
WALL OR CEILING MOUNTING — The product
should not be mounted to a wall or ceiling.
HEAT — The product should be situated away from
heat sources such as radiators, heat registers,
stoves, or other products {including amplifiers}
that produce heat.
ANTENNA
- LEAD IN
WIRE
ANTENNA
_ DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
Pe
GROUND CLAMPS
~~~ POWER SERVICE GROUNDING
ELECTRODE SYSTEM
{NEC ART 250, PART H}
NEC — NATIONAL ELECTRICAL CODE
En

Pioneer XR-A390 Specifications

General

Brand	Pioneer
Model	XR-A390
Category	Speaker System
Language	English