Piranha Optional Tooling and Attachments
Enhance your Ironworker’s Versatility
Oversize Punch Attachments
• Expand punching capacity up to 5"
Quickset Gauging Table
• Allows you to quickly set-up your punch end
for multiple holes.
• Includes an angle gauge bar to index off the
heel of your angle and a plate gauge bar,
which indexes off the end of your plate.
• Extensions are available in left- and right-
hand styles in 5' and 10' lengths.
Backgauge
• Allows you to quickly set-up your machine to
repeat your shearing length by adding a
mechanical backstop.
• Backstop can be positioned in either the
angle, flat bar, or round bar section of the
machine.
• Available in lengths of 3', 6', 9’, or 12'.
• An electronic version is also available, which
cycles the machine automatically when
material makes contact with the backgauge
probe.
Pipe Notching Attachment
• Allows you to single notch Schedule 40 Pipe.
• A must have for handrail jobs.
• Attaches to the punch end of the machine.
• Notching dies available for 3/4", 1", 1-1/4", 1-
1/2", and 2" Schedule 40 Pipe.
Oversize Bending Attachments
• Expand your bending capacity to 24" on most
models.
• Includes a 4-way die block for different
thicknesses of material.
***Additional Options Shown on Inside of Back Cover***
To Next Page
Loading...