Need help?Do you have a question about the Piranha P65 and is the answer not in the manual?
Expand punching capacity up to 5 inches for ironworkers.
Features for quick setup of punch end for multiple holes with angle and plate gauge bars.
Allows quick setup for repeat shearing length using a mechanical backstop.
Recommendations for installing the Piranha ironworker in a clean, well-lit area.
Requirement for a stable base or floor to maintain alignment and prevent undue stress.
Guidelines for safe lifting using the integral lifting lug, cautioning against underside lifting.
Operation of start/stop buttons and the selector switch for control box activation.
Details the five-position momentary joystick for controlling machine movement.
Explains hands-free operation using the footswitch and its three positions.
Step-by-step procedure for aligning the punch and die correctly.
Importance of the hydraulic filter, replacement frequency, and contamination caution.
Ensuring efficiency via proper alignment and tight fasteners, checking hoses and fittings.
Step-by-step checks for power, fuses, transformer, and control circuits.
Differentiates electrical/hydraulic issues with troubleshooting steps.
Identifies causes like low fluid, low voltage, improper limit switches.
Steps for ordering parts including serial number, part number, description, and shipping details.
Illustrates the hydraulic system with labeled components and flow paths.
Lists various shear, bar, angle, and coper knives with quantities.
Template for recording maintenance activities like lubrication and oil changes.
To Next Page
General