1-2
1.3 INSTALLATION
The mobile filter system requires no special installation instructions. Installing and changing the
filter media is described in Chapter 3.
1.3.1 Electrical Connection
The electrical service used by the filter system must comply with local codes. If there are no local
codes that apply, refer to the National Electrical Code (NEC) ANSI/NFPA 70-1990 to install the
service. In Canada refer to CSA Standard C22.1 Canadian Electrical Code Part 1 & 2, and local codes.
Wiring diagrams are provided with the filter system, located inside motor cover.
WARNING
The filter system is equipped with an oil proof, electrical supply cord with a
three prong safety plug. This is to protect operators from electrical shock
hazard in the event of an equipment malfunction. The plug should be plugged
into a properly grounded three prong receptacle. DO NOT cut or remove the
grounding (third) prong from this plug.
1.4 INITIAL ADJUSTMENTS
After the filter system is unpacked, check it thoroughly. During shipment some components may
have loosened and need tightening. Refer to Chapter 3 for filter pickup assembly procedures.
1.5 INITIAL CLEANING
When the filter system is shipped, many of its parts are covered with a thin coat of oil for protection.
Before the filter system is ready for use it must be cleaned. This will remove the oil coating and any
foreign matter that may have accumulated during storage and shipment. All parts of the filter system
(except the main housing) are dishwasher safe. Wash all parts and dry thoroughly before use.
To Next Page
Loading...