Commissioning
After switching the heater on using the On/off switch you can control
the heater using the remote control.
Operation using the remote control:
1. Insert two AAA 1.5V batteries in the remote control. When using
the infrared remote control, always point it directly at the heater
as it does not work if there are any obstacles between the
remote control and the heater.
2. Plug the heater into the socket
3. Then press the On/Off switch (3.) on the side of the heater. The
switch must be in the “I” position. The blue LED (7.)
4. Switching on: Now press the “On” button on the remote control
to switch on the heater. The heater first switches on at 33%,
“Gentle start”. After 4 seconds, it returns to the heating setting
that was last selected. When the heater is used for the first time,
it switches to the maximum setting after 4 seconds. The LED
that was previously blue is now red (7.).
5. Dimming: Using the arrow keys, you can dim the heater to
increase and decrease the intensity. Alternatively, the heater can
also be dimmed by pressing the reset button directly.
6. Switching off: Use the “Off” button to switch the heater off
again. The LED display switches from red back to blue. Then
switch the “On/off switch” to “0” to switch the heater off
To Next Page
Loading...