Step 5)
Position the heater where it is to be installed and mark the drill holes
where the installation bracket will later be screwed to the wall, ceiling
or eaves. Then secure the installation bracket to the wall, ceiling or
eaves using the screws and metal dowels supplied. Then screw the
heater back on the installation bracket. The heater is now hanging
securely on the wall or ceiling.
!!!!
!
Now use the Allen key to adjust the bracket screw on the back of the
heater to set the desired angle for the heater. When angle is chosen,
make sure that no flammable objects are in the proximity of the
chosen angle. Then tighten the screws.
Ensure that the power cable is always directed away from the heater
and is not wound around the heater. This may cause a fire if the
cable heats up by coming into direct contact with the heater and
To Next Page
Loading...