Pittsburgh 3980 - Page 5

SKU 3980 For technical questions, please call 1-800-444-3353. Page 5
Step 4: Place the Hooks of the 2-JAW PULLER HOOK (#2) around the strut spring at the spot you identied
in Step 2 as shown in Figure 2.
Figure 2 -- Proper Hook Placement
Step 5: Adjust the PULLER HOOK to t around the strut spring at the end opposite from Step 4. Make sure
the Strut Spring Compressor is parallel (straight up and down) with the Strut Assembly as shown in
Figure 3.
Figure 3 -- Proper Hook Placement
Step 6: Tighten the NUT until it contacts the PULLER HOOK.
Step 7: Remove the Wing Nuts from two of the SAFETY HOOK (#6).
Puller Hook (1)
Strut Spring
2 Jaw Puller Hook (2)
2 Jaw Puller Hook (2)