PizzaMaster 700 Series - Page 23

23
PizzaMaster®
• Lubricate the door bushings with a non toxic high-temperature spray lubricant.
4 week cleaning
Important! Before starting this cleaning cycle turn off all electrical supplies to the oven
• Cleantheventilationoutletsontheovenstop(frontandback)fromsootandresidue.
• Removethepaneltotheelectricalcompartmentandvacuum-cleantheentireinsidearea.
• Liftoutthehearthstonesandvacuum-cleantheentireovenchamber.
Important!
Be very careful to mark and put back the hearth-stones exactly as they were. Each stone must be retur-
ned to its original place with the same side facing upward and turned in the same direction as before.
12 month cleaning
PizzaMaster has developed a unique range of cleaning and maintenance products especially made for pizza
and bakery ovens. Using these products saves the environment at the same time as they are much easier to use
than conventional oven cleaning products and helps keep your oven new longer.
Product Art. No Suitable for
Oven brush Metal with scraper 50053-01 cleaning the ovens hearth stones
from soot and baking deposits
Oven brush Soft 50053-02 cleaning the ovens hearth stones
from soot and baking deposits
Cleaning cloth package 50341 removing burned soot from ovens stainless steel exterior
no more need for oven cleaners when removing hard burned
soot or deposits, this cloth cleans the ovens stainless steel
exterior dry without the use of any water or cleaning fluids.
Cleaning sponge package 50716 regular exterior cleaning and cleaning oven door glass
sponge with one side that is a regular sponge and the other
side is a scratchy but non abrasive side that makes the daily
cleaning very easy
To order these products contact your nearest PizzaMaster representative or PizzaMaster directly
Environment friendly cleaning
• CleantheovensstainlesssteelfrontexteriorwithaPizzaMastercleaningcloth.Alwayscleanwiththe
grain of the metal.
If oven is equipped with UBC
• Removeallinteriorremovableparts(glassdoors,watercontainer,shelfsupports,dividers,bottomand
top brackets) there is no tool necessary for removing these parts. Clean all surfaces inside of the cabi-
net with a sponge lightly damped with a mix of water and dish fluid. Dry surfaces with a clean soft cloth.
Clean and dry all parts before replacing them into the UBC.
1 week cleaning
Maintenance and Preventative Maintenance