~ 122 ~
All drying programmes end with cooling down period.
1. When the programme is finished, the display indicates « END » and an acoustic
signal sounds.
2. The door lock is deactivated automatically after approx. 2 minutes. The
operational status indicator of the door lock « » goes off.
3. Switch off the appliance using the « ON / OFF » - BUTTON.
4. Close the water tap.
5. Open the door and remove the laundry.
6. Leave the door and the detergent dispenser slightly opened, so the moisture can
escape completely.
5.6 Selection of a new washing programme / function
❖ You must switch off the appliance first to cancel the old settings and to be able
to make new settings.
HOW TO SELECT A NEW WASHING PROGRAMME / FUNCTION
1. During a washing cycle, switch off the appliance using the « On / Off » - button to
cancel all settings.
2. Wait a short period of time before switching the appliance on again.
3. Set a new washing programme and new functions if desired.
4. If needed, set a new spin speed or washing temperature.
5. PLEASE NOTE: do not add more detergent.
6. Press the « START / PAUSE » - BUTTON to start the new programme.
5.7 Reload laundry
WARNING! If you stop a running programme, the temperature of the
water, the laundry and the drum can be very high. Be very careful while
removing the laundry. RISK OF SCALDING! RISK OF BURNS!
It is very important to check the water level and the temperature of the
water in the washing drum before opening the door.
HOW TO RELOAD LAUNDRY DURING A RUNNING PROGRAMME
1. Press the « START / PAUSE » - BUTTON once. The washing / drying cycle is
interrupted.
To Next Page
Loading...