~ 121 ~
3. If the requirements described in point a. above are not fulfilled, the appliance
does not permit the deactivation of the door lock. The operational status
indicator of the door lock « » does not go off. The door cannot be opened.
4. In this case, switch off the appliance using the « ON / OFF » - BUTTON.
5. After a brief period of time, switch the appliance on again.
6. Set the programme « SPIN » using the « PROGRAMME » - BUTTON. Set the spin
speed to « -- » using the « SPEED » - BUTTON (see also chapter 5.3 SELECTION OF
THE ADDITIONAL FUNCTIONS et seq.).
If spin speed « -- » has been selected, the final spin speed will be cancelled. Before
the programme ends, the appliance drains the water only.
7. Press the « START / PAUSE » - BUTTON to start the programme « SPIN ».
8. When the programme is finished, the time display indicates « END » and an
acoustic signal sounds.
9. The door lock is deactivated automatically after approx. 2 minutes. The
operational status indicator of the door lock « » goes off.
10. Switch off the appliance using the « ON / OFF » - BUTTON (see also chapter 5.5
END OF A WASHING / DRYING PROGRAMME).
11. Close the water tap.
12. It is very important to check the water level and water temperature inside the
drum before opening.
13. You can open the door.
If the door lock will not be released and the door cannot be opened, the
temperature inside the washing drum is more than 50 °C or the current
washing / drying programme has progressed too far.
NOTICE! It is not possible to open the door while the door lock indicator is
on. Do not open the door by force. To open the door by force can damage
the appliance seriously. RISK OF DAMAGE!
NOTICE! Any damage to the appliance and / or the door caused by
forcible opening of the door are not subject to the guarantee or the
warranty!
NOTICE! If there is a lot of foam or water in the drum, open the door very
carefully. Use a dry cloth to prevent foam and / or water from leaking out
of the drum while the door of the appliance is opened.
5.5 End of a washing / drying programme
❖ When a programme has ended, the time display indicates « END ».
❖ The door lock is deactivated after approx. 2 minutes.
To Next Page
Loading...