~ 135 ~
5. Reconnect the water inlet hose to the tap.
6. Remove the water inlet hose (A) from the appliance (B / water inlet valve on the
back of the appliance / s. fig. below).
7. Remove the filter (D) from the water valve (B) using a universal pliers (C / s. fig.
below).
8. Clean the filter (D) using some water and a toothbrush (E / s. fig. below).
Fig. similar: fig. serve as an example only.
9. Reinstall the filter (D) properly (s. fig. below).
10. Reconnect the water inlet hose to the appliance again (s. fig. below).
Fig. similar: fig. serve as an example only.
11. Open the tap and make sure that the connections (hose - tap / hose - appliance)
are properly installed and watertight.
To Next Page
Loading...