PLANET ECLIPSE CS3 - Page 40

ELECTRONICS
US ER INT E RFA CE PARA METE RS
C S 3
40
FIG .4
BS OFF ROF PARAMETER
The maximum rate of fire that the marker can
achieve with breech sensor (BS) disabled. 1
> Range: 4.0 - 15.0 bps (balls per
second) In 0.1 increments. 2
1 Should be set to the slowest loader feed rate to
avoid chopping paintballs.
2 Always calibrate your ROF CAP parameters to the
venue ROF meter to avoid penalties.
FIG .3
BS ON ROF PARAMETER
The maximum rate of fire that the marker can
achieve with the breech sensor (BS) enabled.
This parameter is only visible if the ROF CAP
parameter is set to ON.
> Range: 4.0 - 20.0 bps (balls per second)
In 0.1 increments. 1
1 Always calibrate your ROF CAP parameters to the
venue ROF meter to avoid penalties.
FIG .2
ROF CAP PARAMETER
The maximum rate of fire the marker can
achieve.
> ON: ROF limited to the value set by
the BS ON ROF parameter.
> OFF: ROF limited by loader speed.
FIG .1
FIRE MODE PARAMETER
Sets the firing mode of the marker.
> SEMI: One shot per trigger pull.
> RAMP: Assisted firing with multiple
shots per trigger pull under certain
conditions.