PLANET ECLIPSE CS3 - Page 59

C S 3
ELECTRONICS
RE GULATO RY AP PROVAL RN 487 1
59
CERTIFICATIO
N
STANDARDS ARTICLE
LABORATOR
Y
REPORT
NUMBER
Safety
EN60950-1:2006
A11:2009/A1:2010/
A12:2011/A2:2013
(3.1( a ))
TUV
Rheinland
10053210 001
Health EN 62479:2010 10053433 001
EMC
EN 301 489-1 V1.9.2
(3.1( b )) 10052964 001
EN 301 489-17 V2.2.1
Radio EN 300 328 V1.9.1 (3.2) 10053433 001
Notied body
opinion
10048936 001
UNITED STATES
CONTAINS TRANSMITTER MODULE - FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CANADA
CONTAINS TRANSMITTER MODULE - IC: 12246A-BM71S2
This device complies with Industry Canada’s license exempt RSS. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
EUROPE
Compliance testing for transmitter module: