Planet GS-4210 SERIES - Introduction to the Planet GS-4210 Series Switch

10
5. RepeatStep1tocheckiftheIPaddresshaschanged.
If the IP is successfully congured, the Managed Switch will apply the new IP
address setting immediately. You can access the Web interface of Managed Switch
throughthenewIPaddress.
If you are not familiar with console command or the related parameter,
enter“?”anytimeinconsoletogetthehelpdescription.
3.3 StoringCurrentSwitchConguration
In switches, the running conguration le is stored in the RAM. In the current
version, the running conguration sequence can be saved from the RAM to FLASH
by saving command or copying running-cong startup-cong command, so
that the running conguration sequence becomes the startup conguration le,
whichiscalledcongurationsave.
1. On “GS-4210-24T4S #”prompt,enter“copy running-cong startup-cong”
asshowninFigure3-8.
Figure 3-8: Saving the Conguration Screen