The POE-161S separates the power out and provide two kind
of DC power output through its DIP switch and its voltage and
current shown as below:
- 5V DC / 4.5A
- 12V DC / 2A
The default value will be set on 5V.
Please check the power requirement of the device
that is going to get the power from POE-161S. If
the power requirement is higher than POE-161S
can supply, current overload will shutdown the
POE-161S itself. Thus, it will shutdown your device
as well.
POE-161 and POE-161S can be installed in pair. However, use
of third-party device is allowed if the device complied with IEEE
802.3at Power over Ethernet pre-standard.
To Next Page
Loading...
