What to do if the Plastaket Manufacturing Juicer motor will not start?
The juicer will not start unless all parts are correctly positioned. Check the screen holder sensor, located closest to the motor hub, for any possible damage.
Why is my Plastaket Manufacturing Juicer making a squealing or abnormal sound?
A squealing or abnormal sound could indicate a possible motor problem. Contact the Service Department immediately.
How to fix wet pulp in Plastaket Manufacturing Juicer?
Wet pulp can result from a clogged screen. Turn off the juicer, remove the screen, clean it, reassemble the juicer, and continue juicing.
Why does my Plastaket Manufacturing Juicer run slowly?
Overloaded circuits can cause the juicer to slow down and become clogged. The Champion 2000+ Juicer requires a standard 110-volt, 5 amps service. Other countries may use 220-240 volt, 50 hertz.
What to do if my Plastaket Manufacturing Juicer is making a clicking sound?
A clicking sound indicates that the juicer is being fed too rapidly. Unclog the juicer by holding the tamper down with one hand and applying downward pressure on the tapered end of the body with your other hand.
Why is my Plastaket Manufacturing Juicer dripping black or brown oil?
Dripping black or brown oil indicates a possible seal failure. Discontinue use of the juicer and contact the Service Department.
Why is the juice from my Plastaket Manufacturing Juicer hot?
The juice may be hot because you are feeding the juicer too slowly, or the cutter may be dull.
Why is my Plastaket Manufacturing Juicer leaking?
Some juice leakage is normal on the juicing chamber since there are no gaskets.
Essential safety rules for operating the Champion 2000+ Juicer to prevent accidents and ensure safe use.
Visual guide and labels for all parts of the Champion 2000+ Juicer.
Details on the 10-year limited warranty, coverage, and exclusions for the juicer.
Details on the juicer's limited warranty, including coverage, exclusions, and how to file a claim.
Instructions for correctly assembling the Champion 2000+ Juicer for operation.
Advice on preventing the cutter from sticking and proper cleaning.
Steps for safely dismantling the Champion 2000+ Juicer after use.
How to wash and maintain the nylon parts and juicer body after each use.
Method for removing difficult food stains from juicer parts using bleach solution.
Introduction to the grain mill attachment and general grinding procedures.
Guide to diagnosing and resolving common problems encountered with the juicer.
General| Brand | Plastaket Manufacturing |
|---|---|
| Model | Champion 2000+ |
| Category | Juicer |
| Language | English |
To Next Page