EasyManua.ls Logo

Platek MINI - Safety and Warnings

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MINI drive over
4 PLATEK - USER GUIDE
TECHNICAL DATA
SAFETY AND WARNINGS
Sicherheits- und Installationshinweise:
Die Montage und der elektrische Anschluss dürfen nur von entsprechend qualizierten
Fachkräften durchgeführt werden.
Arbeiten an der Leuchte dürfen nur im spannungsfreien Zustand durchgeführt werden.
Netzanschluss entsprechend den Anforderungen der Errichtungsbestimmungen
durchführen.
Die Netzzuleitung darf nicht entfernt werden.
Die werksseitig vormontierte Netz-Zuleitung kann im Falle von Beschädigung nicht
bauseitig ersetzt werden. Die Netz-Zuleitung muss für die Verlegung im Erdreich
zugelassen sein.
Es sind zertizierte Schraubklemmen 250V, 3 x 2,5 mm�, 3 x 1,5 mm� oder 2 x 1,5
mm� und Abschluss- bzw.Abzweigdosen der Schutzart IP 68 zu verwenden.
Leuchte nur mit unbeschädigter Scheibe betreiben.
Safety and warnings for installation:
Installation and start-up must be carried out by qualied personnel only.
Carry out operations on device only with device disconnected from power supply.
Connect to mains following the installation regulations in force.
Do not remove power cable.
The external exible cable of this device cannot be replaced; if damaged, the device
must be destroyed.
Connection to the mains must be performed with certied screw connectors, 250V, 3 x
2.5 mm
2
, 3 x 1.5 mm
2
, 2 x 2.5 mm
2
or 2 x 1.5 mm
2
, in branch box with protection level
IP 68.
Use the device only with a complete glass.
Sicurezza e avvertenze per l’installazione:
L’installazione e la messa in funzione devono essere eseguite esclusivamente da
personale qualicato.
Eseguire lavori agli apparecchi esclusivamente a tensione nulla.
Effettuare il collegamento alla rete seguendo le normative d’installazione vigenti.
Non rimuovere il cavo di alimentazione.
Il cavo essibile esterno di questo apparecchio non può essere sostituito; se il cavo è
danneggiato, l’apparecchio deve essere distrutto.
La connessione alla rete deve essere con morsetti a vite certicati, 250V, 3 x 2,5 mm�,
3 x 1,5 mm�, 2 x 2,5 mm� o 2x1,5mm�, in scatola di derivazione con grado di
protezione IP 68.
Utilizzare l’apparecchio solo con vetro completo.
IT
EN
DE
8
max. 30