Platinum Health PHB3300 User Manual

Carousel Sliding Bath Bench with Swivel Seat
Model PHB3300/PHB3400G
ASSEMBLY AND OPERATION MANUAL
Thank you for investing in Carousel Sliding Bath Bench with Swivel Seat. Safe and
comfortable bathing is only a few steps away. Please be sure follow all instructions carefully
to ensure safe and trouble-free operation for years to come.
IMPORTANT SAFETY INFORMATION
READ ALL SAFETY INFORMATION BEFORE USING
It is the users responsibility to ensure the appropriateness of this device for the user in
question before using.
• NEVER use this device with individuals who are severely mentally, cognitively, physically
or vision compromised.
• ALWAYS attach safety belt and adjust to a snug t around users hips.
• NEVER leave a compromised user unattended.
• ALWAYS ensure that the legs are properly adjusted to ensure that the bench is level side
to side and front to back.
• NEVER exceed the maximum weight capacity of 330 lbs.
NOTE: Failure to follow the above noted safety instructions can lead to severe injuries.
ASSEMBLY
STEP 1
Remove all parts from the box and remove all plastic
packaging. Ensure all parts are present as shown
here. In the event of missing parts, please call cus-
tomer service at 1-888-550-2410.
STEP 2
Insert the curved upper leg sections into frame of
shower chair as shown. Slide parts together until the
brass tension spring buttons pop out of the holes.
NOTE: only two tension spring buttons will show the
other two tension spring buttons need to be pressed
so the legs slide into the tube.

Platinum Health PHB3300 Specifications

General

Weight Capacity	300 lbs
Frame Material	Aluminum
Seat Depth	16 inches
Weight	36 lbs
Wheel Size	24 inches
Armrest Style	Desk-length
Footrest Style	Swing-away
Seat Width	18 inches

Summary

Important Safety Information

Read All Safety Information Before Use

Emphasizes user responsibility to ensure device appropriateness and read all safety information prior to use.

Assembly Instructions

Step 1: Part Identification

Remove all parts from packaging, verify completeness, and contact customer service for any missing items.

Step 2: Attach Upper Leg Sections

Insert upper leg sections into the frame, ensuring spring buttons pop out to secure the connection.

Step 3: Attach Lower Leg Sections

Attach one lower leg section to each corner of the frame as shown in the diagram.

Step 4: Insert Backrest

Insert the backrest into the frame until the spring tension buttons engage securely in the holes.

Step 5: Adjust Leg Height

Adjust leg heights using spring buttons for desired client height and ensure the seat is level.

Operation Guide

Step 1: Engage Sliding Function

Engage the chair sliding function by pushing the gray button, sliding the chair to lock at the end of the rails.

Step 2: Rotate and Secure User

Rotate the chair by pushing the red lever, locking every 90 degrees, then secure the user with the safety belt.

Step 3: Transfer into Tub

Rotate the chair, lift user's leg, press gray button to disengage sliding, and slide chair into the tub.

Step 4: Bathing

Proceed with bathing as usual once the chair is correctly positioned in the tub or shower.

Step 5: Exit Tub

Press gray button to disengage sliding, slide chair out, press red lever to rotate, and unlock belt for exit.

Troubleshooting Common Issues

Chair Not Sliding Smoothly

Apply light WD-40 lubricant to horizontal rails if the chair does not slide easily or smoothly.

Chair Not Level

Adjust rubber feet and ensure brass tension knobs are correctly positioned for a level chair.