GEMORO PLATINUM PRO501VXP 4
maintaining the subtracted weight in its memory.
The display will then show 0.0g. If you then take
the tray off of the weighing platform, from its
memory the display will show a negative weight
equal to the weight of the tray or whatever was on
the weighing platform. After placing the tray back
on the weighing platform, you may then place the
item that you wish to weigh directly into the tray
and weigh it independently. When you no longer
wish to use the tray, you may press the TARE
button once again to bring the display back to
0.0g or press the POWER button once to turn the
scale off since both of these steps will subtract the
weight from its memory.
3. CAL – Push this button to initiate the scale’s
calibration process. To calibrate the scale, please
refer to the CALIBRATION PROCEDURE section
noted below.
4. PCS – Push this button to initiate the scale’s
parts counting PCS feature. Please refer to the
COUNTING FEATURE (PCS) section noted below.
5. MODE - Push this button to scroll through the
scale’s weighing modes. Simply press the button
once to scroll though each weighing mode until
you find the desired unit of measure.
To Next Page
Loading...