21
Stationing Ledge Covers:
Step 8
• By using a 1/4” drill bit, drill one centered opening in four Ledge Covers according to the illustration
below on the le, making this hole 1.5” from the top of the Ledge Covers. Next, place and screw these
four Ledge Covers into the four Corner Posts, using 1” self-tapping screws as demonstrated below.
Note: Before screwing for easier screwing, please pre-drill all the necessary openings by using a 1/8”
drill bit through the pre-drilled ¼” openings mentioned.
• By using a 1/4” drill bit, drill one centered opening in each Buttress Post according to the illustration
below on the le, making this hole 1.25” from the top of the Vertical Stand. Next, put one Ledge
Cover over each Buttress Post and screw one 1” self-tapping screw through each Buttress Post and
Ledge Cover into the inner wall of each Buttress Post as illustrated below.
Note: Before screwing for easier screwing, please pre-drill all the necessary openings by using a 1/8”
drill bit through the pre-drilled ¼” openings mentioned.
• Aerwards, recheck all levels and squareness of the pool again, making sure that all of the Wall
Panels are exactly squared o and the same height level with each other.
To Next Page
Loading...