13
Replacement Instructions
If PlayNetwork’s Customer Service representative indicates that your C500 player needs to be replaced,
please follow the directions below after you receive a replacement Combo unit:
1. Power down the C500 player and all other audio equipment including the amplifier and remove the
power cord from the C500 player and the wall outlet.
2. Note which audio cable is plugged into the “Zone 1” and “Zone 2” audio outputs, and disconnect the
audio cables from the player.
3. If a network cable is connected, disconnect the CAT5 network cable.
4. Place the unit into the packaging material of the new replacement unit for return shipment to
PlayNetwork.
5. Connect the audio cables to the “Zone 1” and “Zone 2” audio outputs on the replacement player as
noted above.
6. If connected before, connect a CAT5 network cable to the connector on the back of player.
7. Connect the power cord to the new replacement player.
8. Then turn on all other audio equipment.
© 2009 PlayNetwork Inc. All rights reserved.
Combo and AutoPlay are trademarks and PlayNetwork and the PlayNetwork
logo are registered trademarks of PlayNetwork Inc. or its affiliates in the
U.S. and certain other countries. All other trademarks mentioned in this
document are the property of their respective owners. (0403R)
8727 148TH AVE., NE. REDMOND WA 98052 1.888.567.7529 www.playnetwork.com
To Previous Page
Loading...
