14
Braking force
CAUTION!
The braking force must be set in such
a way that the rear wheel spins freely
when the brake lever is released and
jams when the brake lever is tightened.
Press the brake arm (S1) in the direction of the
arrow. Turn the adjuster and the lock nut (S2) to
the left to reduce the braking force, and turn the
adjuster and lock nut to the right to increase the
braking force (Fig. R).
Storage, cleaning
Always store the product in clean and dry condi-
tion at room temperature.
Only use water to clean and wipe it dry with
cleaning cloth.
IMPORTANT! Never clean the product with
aggressive cleaning agents.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the packa-
ging materials out of the reach of children.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by
this warranty. With regard to complaints, please
contact the following service hotline or contact
us by e-mail. Our service employees will advise
as to the subsequent procedure as quickly as
possible. We will be personally available to dis-
cuss the situation with you. Any repairs under the
warranty, statutory guarantees or through good-
will do not extend the warranty period. This also
applies to replaced and repaired parts. Repairs
after the warranty are subject to a charge.
Make sure that the nut is tightly
screwed to the axle bolt.
7. Attaching handlebar protection
Mount the impact protection (1) to the
handlebars by the Velcro fasteners (Fig. M).
8. Sticker sets
Stick the sticker set 1 or set 2 (19) on the
positions specified (Fig. N).
Settings
Handlebar height
Observe the maximum extension
height!
Push up the cap.
Loosen the clamp until the handlebars can
be pushed up and down and then set the
handlebars to the appropriate height.
Tighten the clamp again and then push the cap
over the clamp (Fig. O).
Saddle height
Note:
The saddle height is set correctly if the
child can reach the ground securely
with their feet.
Observe the maximum extension
height!
Push up the cap. Loosen the nut until the saddle
can be pushed up or down. Set the saddle to the
appropriate height, retighten the nut and push
the cap down again (Fig. P).
Brake
Bowden cable
Make sure that the brake Bowden cable is cor-
rectly routed to the handlebars (Fig. H).
Brake lever
The distance from the grip to the brake lever
must not exceed 60mm. Adjust the distance of
the brake lever (18) to the grip by adjusting the
stop screw (Fig. Q).
GB/IE
To Next Page
Loading...