PLAZA Magnador - User Manual

Heavy Duty Magnet Pet Door
Plaza Enterprises
Installation Instructions
Items Provided
 Installation Template
 Wood screws equal to number of mounting holes in the frame
 2 sets of black locking nuts and bolts
Items Required
 Good exterior caulk such as Silicone or Vulkem
 Pencil
 Electric drill with 1/8” and 3/8” bits
 Jig saw
 Straight Edge
 Masking Tape
 Phillips Screwdriver
Caution
Please read the instructions carefully. Improper installation may cause damage to your
Magnador™ and VOID any manufacturer warranty. This installation template is a guide.
Before cutting and installing your door, please verify your marks with the actual product.
Step 1:
 Identify the location for your Magnador™ pet door.
 Check the surrounding are to make sure there is nothing that will interfere with
the full swing range of the hinged door panel.
 Improper installation of the door may result in damage to surrounding areas and
negatively impact the operation of the door and proper usage by the pet.
Step 2:
 The Magnador™ pet door must be installed on a flat surface.
 Use the shoulder height of your tallest pet to set the height of the opening for the
Magnador™ pet door.
Step 3:
 After you have determined the location and proper mounting height for your
Magnador™ pet door, use masking tape to fasten the template to the mounting
location.
 Use a pencil to mark the screw positions through the marks on the template.
 Mark the 4 corners through the marks on the template.

Summary

Installation Instructions

Safety Cautions

Read installation instructions carefully to avoid damage and warranty voiding.

Step 1: Location and Clearance

Identify pet door location and check for interference with the hinged panel's swing.

Step 2: Surface and Height Setup

Ensure a flat surface and set opening height by pet's shoulder height.

Step 3: Template Marking

Fasten template to location and mark screw positions and corners with a pencil.

Step 4: Cutting the Opening

Drill pilot holes and cut the door opening along marked lines using a jig saw.

Step 5: Mounting and Sealing

Install door, apply caulk for seal, and tighten screws evenly for a weather-tight fit.

Step 6: Adjusting Magnetic Force

Modify magnet spacing to adjust holding power and ensure smooth door panel swing.

Step 7: Locking Mechanism

Use locking bolts to fix the door in place or allow it to swing freely.

PLAZA Magnador Specifications