Plejd DIM-02 User Manual

DIM-02
0306.3.3
Mains electricity
230 V/50 Hz
Standby power
0.3 W
External operating temperature
-20 to +35 °C
Dimensions
46x46x18 mm
Load type
Trailing edge
Leading edge
Protection
Overtemperature software
Overtemperature hardware
Overload software
Radio
2.4 GHz mesh
Bluetooth
®
<10 dBm
Radio range
Approx. 10 m indoors
The Plejd mesh technology extends the range by
allowing the units to communicate with each other.
RISK OF INJURY TO PERSON OR PROPERTY
All work on the appliance must be carried out by
an authorized electrician. National laws and
regulations must be followed.
Compliant to standards
Hereby, Plejd AB declares that the radio
equipment type DIM-02 is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address: plejd.com/compliance
EN
INSTALLATION MANUAL
Further information can be found
in the Plejd app or at plejd.com
Plejd AB, Krokslätts Fabriker 27A
431 37 Mölndal, Sweden
Disposal and recycling
This electrical product should not be disposed
of together with other household waste. Contact
your local recycling center for guidance on
electrical and electronic equipment disposal.
Important information
Do not use the product if it has visible signs
of damage.

Plejd DIM-02 Specifications

General

Type	Dimmer
Voltage	230 V AC
Max Load (Incandescent)	400 W
Maximum load (VA)	400 VA
Mounting	DIN rail
Power	400 W
Frequency	50/60 Hz
Wireless	Yes
Compatibility	Plejd system
Weight	0.1 kg
Current	1.74 A

Summary

Product Safety and Compliance Information

Risk of Injury or Property Damage

Work on appliance must be by authorized electrician. Follow national laws and regulations.

Standards Compliance Declaration

Declaration of conformity for DIM-02 with Directive 2014/53/EU. Full text available online.

Important Product Handling

Do not use the product if it has visible signs of damage.

Disposal and Recycling Guidelines

Electrical product should not be disposed of with household waste. Contact local recycling center.

Installation and Setup Guide

Connect the Product

Install product in appliance box, behind push button/box lid, or with mounting clip.

Follow App Instructions

Download Plejd app, supply power, and use app to complete installation. Requires Bluetooth and internet.

Hand Over Plejd System

Find system code in app, write on sticker, place in distribution box, give to customer.

Control Inputs and Wiring

Control inputs 1 & 2 can be used with push button, light switch, or motion sensor.

Support Contact