57
Why is my PLEO rb not turning “ON”?
1. Make sure the battery has been charged for four hours.
2. Double check the “Power ON” indicator to make sure that PLEO rb
has been switched on properly (see page 18, “Charging PLEO rb’s
Lithium Polymer battery).
3. In the daytime, check to see if PLEO rb is resting by gently nudging
or tapping PLEO rb to wake him/her up.
4 In the nighttime, check to see if PLEO rb is sleeping by pressing the
power ON button to wake him/her up (during the night, he/she will fall
asleep again very quickly).
5. Much like a cell phone battery, the PLEO rb battery may eventually
need to be replaced. Log onto www.pleoworld.com for more information
on purchasing a replacement rechargeable battery pack. Please note:
PLEO rb contains a special Lithium Polymer rechargeable battery pack.
Do not use any other battery pack not explicitly designated for PLEO
rb, as it may not operate correctly and may cause damage.
My PLEO rb is too loud. How do I adjust or mute the volume?
Power “ON” PLEO rb, then press the “ON/OFF” button once to “Mute,”
a second time for “Soft Volume” and a third time for “Normal Volume.”
Please note the complex gears and motors inside of PLEO rb may cause
a moderate level of noise any time PLEO rb is in motion.
To Next Page
Loading...