operating manual BAIndustrie_UK 7
Injuries due to crushing, being caught up
Malfunction due to electromagnetic interference.
The control and phase cables must not be extended. The
product must be inspected and the fastening must be
controlled again before commissioning.
Modifications to the product are not permitted.
The supply and return cables must be laid together.
Cables must be shielded.
Danger from magnetic radiation
Malfunction / destruction of magnetically sensitive parts.
The motor must never come into contact with magnetically
sensitive parts such as pacemakers or data carriers. The
strong magnets can lead to damage and/or malfunction or
extinction of these.
Crushing, pulling in / being caught up
Caused by careless touching and too small a distance from
rotating parts.
There must be sufficient distance retained to the motor so that
no people or objects can be caught up or drawn in.
Burns
Caused by carelessly touching hot surfaces.
After operation of the product, the surfaces may still be hot.
Always allow the product to cool down.
Thermal overload / destruction
Always ensure sufficient cooling for the motor (air or water
cooling).
A high load on the motor is only permissible in short
operation. Under no circumstances may the motor exceed
the temperature of 100°C.
After each use, the motor must cool down again to ambient
temperature.
Only control systems and regulators approved by us may be
used. You will find an overview on our homepage.
To Next Page
Loading...
