15
Important information
In order to use the Smile P1 you will need a smart meter with P1-port
(P1 telegram DSMR 2.2 and higher).
In order to use the Smile P0 you will need a main meter with optical serial
communication port (according to EN-IEC 62056-21) which allows to be read
out.
The installation of the Smile S0 should be executed by a registered installer.
In order to use the Smile S0 you will need a pulse meter with S0 class A, 24
VDC pulse output (according to EN-IEC 62053-31).
S0 wires from the Smile may only be connected to a S0 output in accordance
with EN-IEC 62053-31.
You will need a network connection.
Check the WiFi connection beforehand and check if a free power socket is
available near the boiler.
You will need a smartphone, tablet, or computer to connect the Smile to your
network.
To Next Page
Loading...