3
Cleaning and maintenance to be performed by the user, should not be per-
formed by children without supervision.
Caution: some parts of this product can get very hot and cause bur-
ns. Particular attention must be paid when children and vulnerable
people are present.
The equipment must under no circumstances be covered by clothing, or
any other object, nor placed under a cabinet or any other obstacle that pre-
vents the circulation of hot air.
WARNING:
To avoid overheating, DO NOT COVER the heating
appliance.
The heating appliance must not be placed immediately below a socket outlet.
If your radiator is a dry type, it can be connected only to a supply with sys-
tem impedance no more than 0,24 Ω. In case necessary, please consult
your supply authority for system impedance information.
Avoid the use of extension cords as these can cause overheating and cau-
se a re risk. However, in case of using an extension cord, the cable must
be the minimum size 14 AWG and with a power no less than 2500w.
The connecting cables of the heater itself must not come into contact with
the surface of the appliance, and in the event that they can come into con-
tact with each other, they must be protected with an insulating cover having
an adequate temperature level.
The equipment must not be installed in places where there is a risk of
splashing water, such as bathtubs, washbasins, etc.
The equipment must be installed so that the switches, thermostat, out-
let cannot be touched directly or indirectly by a person in the bathtub or
shower (respect the distances of prohibition according to RBT).
In case the power supply cable is damaged, it can only be replaced by the
Technical Assistance Service, in order to avoid risks.
Always respect the safety measures when xing the device on the wall.
The electrical installation must have a switch with a fuse and magnetic protection.
To Next Page
Loading...