4. Configuring specific apps
OBD Auto
Doctor
1. Select ‘Extras’ (bottom right corner of the screen)
2. Under Settings select ‘Connectivity’
3. Select the WiFi option
The IP address should be 192.168.0.10 the port 35000
4. Select Status (bottom left corner of the screen)
5. Select the Connect (Chainlink icon in the top right corner of the
screen)
OBD Auto Doctor should now be connected and reading
parameters from your car.
Harry's
LapTimer
Rookie /
Petrolhead /
Grand Prix
Harry’s should automatically connect after 10–15 seconds. If
Harry’s does not automatically connect:
1. Select Administration > Settings > Expert Settings
2. Make sure that Use Wi-Fi Sensors is turned on
3. Select < Settings then < Administration and select Sensor List
4. KiwiWifi OBD should be a listed sensor.
If still experiencing problems skip to the troubleshooting sect
ion
OBD Car
Doctor
OBD Car Doctor is currently not compatible with Kiwi 2+ for
iPhone. Updates coming soon.
DashCommand DashCommand should automatically connect. Follow the Kiwi 2+
will not connect troubleshooting steps.
To Next Page
Loading...