PMD PRO - Cleaning Device Components

Cleaning & Maintenance
Cleaning the Device
Step 1: Clean cap with rubbing alcohol or an anbacterial soap.
Step 2: Clean lter with warm water and rubbing it between
ngers and thumb.
Step 3: Once completely dry, place lter back in the device. If it is
not completely dry, vacuum will not work. (Do not put black lter
in wet).
IMPORTANT NOTE
For best results, replace the discs every 2 to 4 treatments,
since the aluminum oxide crystals that provide the exfoliaon
for your skin will wear o. The length of each treatment will
determine how long each disc will maintain its grit.