How to Calibrate the Device:
Step 1: Make sure that the Machine is in weighing mode
Step 2: Keep Weight on the Pan/ platform (near 30% of maximum capacity.)
Step 3: Press MR Key and hold then press MODE key
Step 4: Display Show PASSWAD (Enter)
Step 5: If display shows READML (Then check your weight)
Step 5: Display show 00000 (feed above weight by M+& MR Keys)
Step 6: Press ENTER KEY to complete calibration.
How to set up Piece counting mode:
Step 1: Make sure that machine is in weighing mode.
Step 2: Keep some pieces on the pan/ platform.
Step 3: Display shows you the weight.
Step 4: Press MR Key & M+ Key display show COUNT
Step 5: Then press TARE/ENTER key
Step 6: Display show P. 00000
Step 7: Enter the number of pieces which kept on the pan (press Enter key)
Step 8: Now machine working in counting mode.
Step 9: For weight mode, press again MODE key.
To Previous Page
Loading...