EasyManua.ls Logo

PNI 150W - Page 2

PNI 150W
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PNI 150W Power inverter
User manual
Please read this manual carefully before using the device .
The inverter can be used to power small and medium size electronics, like a laptop, radio,
mini TV, etc .
1
Power indicator
Alarm indicator
220V socket
Power plug
USB out
On/Off button
Device description
Troubleshooting:
If the invertor doesn’t work properly check the following possible causes:
Ÿ the device doesn’t start
- check if the power plug is connected correctly in the lighter plug of the vehicle
- check the fuse in the power plug; if it is blown please change it with a similar one
(15A)
- check the power cable to be continuous
Ÿ reduced output power:
- the inverter is overloaded: reduce the number of connected electronics
- the inverter is overheated: reduce the number of connected electronics or turn off
the device and wait for it to cool down
Max. 15A
Ÿ inverter auto shutdown
- check the vehicle’s battery, it might be discharged; turn on the ignition to recharge
the battery then use the inverter again
Basic operation:
Follow the steps bellow to power an electronic device through the inverter:
1. Connect the power plug of the inverter in the lighter plug of the vehicle
2. Turn on the inverter
3. Connect the electronic device to the 220V socket or USB port
4. Turn on the electronic device
Attention:
Ÿ Use the inverter only in well ventilated environments
Ÿ Keep the device away from direct sunlight, water, moist, oil, grease and
flammable substances
Ÿ Keep the device away from children
Ÿ Do not use the device to power fluorescent lamps
Technical specifications:
Ÿ Input voltage : 10~15V DC
Ÿ Current drain: <0.3A in standby / 15A with full load
Ÿ USB output: 5V / 2.1A
Ÿ Output voltage: 220~240V
Ÿ Output signal type: modified sine wave
Ÿ Output frequence: 50 Hz
Ÿ Output power: 150W continuous / 450W peak
Ÿ Efficiency : 85~90%
Ÿ Battery low pre-alarm: 10.5V
Ÿ Battery low auto shutdown: 10± 0.5V (after 6 sec)
Ÿ Overheating protection: 60± 5°C
Ÿ Overload protection: Yes
Ÿ Short circuit protection: Yes
Ÿ High input voltage protection: Da
Ÿ Battery polarity protection: Yes, by fuse
Ÿ Fuse: 1x15A
Ÿ Cable: 55 cm length
Ÿ Size: 175 x 71 x 65 mm
Ÿ Weight: 450 g
2
Alarm signals (red LED):
Battery low pre-alarm:
Battery low auto shutdown:
Overload:
Overload auto shutdown: constant
Overheating:
Overheating auto shutdown:
High input voltage:
MP3 player or others

Related product manuals