PNI VX6500 User Manual

User manual 1
English
PNI VX6500 microphone with VOX function
Technical specifications
• Impedance: 1000 Ohms
• Frequency: 3KHz
• Connector: RJ45
• Power supply: 12V (through the RJ45 socket)
• VOX sensitivity levels: 4
• VOX Delay levels: 4
• Background noise reduction: Yes
• Dimensions: 55 x 30 x 78 mm
• Operating temperature: -26° ~ +60°C
VOX sensitivity adjustment
1. Long press the ▲ key to enter the VOX sensitivity setting mode. The microphone will
emit a long beep and the red LED will light up.
2. Briefly press the ▲ key to move to the next sensitivity level. There are 4 levels. The
level of sensitivity is indicated by the number of beeps emitted by the microphone,
accompanied by as many flashes of the red LED. For example, if you set level 3, you will
hear 3 beeps and the red LED will flash 3 times.
3. Press the PTT key to confirm.
Note: The most sensitive level is level 1 and the least sensitive is level 4. We recommend setting the
microphone to level 1.
Setting VOX Delay
Vox Delay is the time between the end of the signal and the end of the VOX transmission.
1. Long press the ▼ key to enter the VOX Delay level setting mode. The microphone will
emit a long beep and the red LED will light up.
2. Briefly press the ▼ key to move to the next level. There are 4 levels. The delay level is
indicated by the number of beeps emitted by the microphone, accompanied by as many
flashes of the red LED. For example, if you set level 3, you will hear 3 beeps and the red
LED will flash 3 times.
3. Press the PTT key to confirm.
Note: The shortest delay time is on level 1.

PNI VX6500 Specifications

General

Type	Condenser
Directivity	Omnidirectional
Frequency Response	50Hz - 16kHz
Output Impedance	2.2kΩ
Operating Voltage	1.5V
Connector	3.5mm
Color	Black
S/N Ratio	58dB

Summary

Technical Specifications

VOX Sensitivity Adjustment

Enter VOX Sensitivity Setting Mode

Long press the ▲ key to enter the VOX sensitivity setting mode, indicated by a long beep and red LED.

Adjust VOX Sensitivity Level

Briefly press the ▲ key to cycle through 4 sensitivity levels, indicated by beeps and LED flashes.

Confirm VOX Sensitivity Setting

Press the PTT key to confirm the selected VOX sensitivity level.

Setting VOX Delay

Enter VOX Delay Setting Mode

Long press the ▼ key to enter the VOX Delay level setting mode, indicated by a long beep and red LED.

Adjust VOX Delay Level

Briefly press the ▼ key to cycle through 4 delay levels, indicated by beeps and LED flashes.

Confirm VOX Delay Setting

Press the PTT key to confirm the selected VOX delay level.