User Manual(Draft）
FCC Model: F8 ,BF-V8,F8i, F8U, F8X
IC Model: F8 ,BF-V8
ATTENTION
Pofung F8 is a multi-task FRS transceiver. Combining the latest technology in radio communication along with a sturdy
mechanical frame, F8 is the ideal and effective solution for the professionals who need to stay in touch with the working
team (in construction sites, buildings, shows, trade fairs or hotels) or for leisure users that just want to keep up with
friends and family.
To help you ward off bodily injury or property loss that may arise from improper operation, please read all the information
carefully before using our products.
Intended Use
Our products are designed to provide reliable wireless communication services for users across many industry sectors. In
order to use the products safely and to achieve the best performance, they must be used as intended. The operator of the
product is responsible for damage to the product or damage caused by the product if the product was used beyond the
intended use instructions.
Intended use includes that:
• The product is used by users who have full knowledge of its RF exposure and can exercise control over their RF exposure
to meet the occupational limits in FCC/ICNIRP and international standards.
• All the security instructions set forth in this document are always heeded.
• The general, national and in-house safety regulations are heeded.
• The product is exclusively used with the frequencies licensed by the respective authority.
• The product is configured appropriately by the dealer.
Besides, intended use also requires the product operator to be well-trained and to be familiar with the applicable
standards, regulations and provisions.
REGULATORY Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
Important: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this device. Your radio is set up to transmit a regulated signal on an assigned frequency. It is
against the law to alter or adjust the settings inside the radio to exceed those limitations. Any adjustments to your radio
must be made by qualified technicians.
To be safe and sure:
• Never open your radio’s case.
• Never change or replace anything in your radio except the battery.
Your radio might cause TV or radio interference even when it is operating properly. To determine whether
Your radio is causing the interference, turn it off. If the interference goes away, your radio is causing it.
Try to eliminate the interference by moving your radio away from the receiver. If you cannot eliminate the interference,
the FCC requires that you stop using the radio.
Hazardous Environments: Do not operate the radio in hazardous environments. Explosion or fire may result.
Do not operate the radio near unshielded electrical blasting caps.
Under certain conditions, radios can interfere with blasting operations and may cause an explosion. Turn your radio OFF
to prevent accidental transmission when in a blasting area or in areas posted: "Turn off two-way radio." Construction
crews often use remote control RF devices to set off explosives.
RF EXPOSURE INFORMATION
WARNING! Read this information before using the radio. In August 1996 the Federal Communications Commission (FCC)
of the United States with its action in Report and Order
FCC 96-326 adopted an updated safety standard for human
Exposure to radio frequency electromagnetic energy emitted by FCC regulated transmitters.
Those guidelines are consistent with the safety standard previously set by both U.S. and
To Next Page
General
