To Next PageTo Next Page
Need help?Do you have a question about the Pocket Wizard Plus X and is the answer not in the manual?
Lists all accessories and cables included in the package with the PocketWizard PlusX device.
Connect the transmitter to the camera and power it on for operation.
Configure the operating channel for the transmitter to establish communication.
Connect receivers to flashes, then match their channels to the transmitter.
Final step to take photos using the synchronized camera and flash setup.
Describes TTL flash functionality when used directly on the camera.
Describes non-TTL flash usage when mounted on a camera bracket.
Instructions for remotely triggering the camera shutter using PocketWizard.
How to set up auto relay mode for synchronized remote camera triggering.
Information about the availability of remote shutter release cables.
Guidance on achieving optimal range through height and mounting options.
Advice on maintaining a direct line of sight for optimal signal reception.
How to adjust device position for best radio signal reception.
Explains what the status LED indicates, including battery level and triggered events.
How to activate transmit-only mode and its unique LED indicator pattern.
Details the two-year limited manufacturer's warranty for the product.
Provides company address and contact email for warranty and support.
Important information and warnings from the FCC regarding device operation.
States compliance with FCC and Industry Canada standards for licensing exemption.
Specifies operating frequencies, recommended battery type, and temperature ranges.
Details sync voltage, radio delay, device dimensions, and weight.
General| Type | Transceiver |
|---|---|
| Antenna | Internal |
| Voltage | 3V |
| Range | Up to 1600 feet (500 meters) |
| Maximum Sync Speed | 1/250 second |
| Connectors | 3.5mm sync port |
| Sync Port | 3.5mm |
| Frequency | 340-354 MHz (depending on region) |
| Compatibility | Most camera systems with PC sync or hot shoe |
