To Next PageTo Next PageHow to fix POFUNG Transceiver not turning on?
If your POFUNG Transceiver won't turn on, the battery may be installed improperly; remove and reattach it. The battery power may have run out, so recharge or replace it. The battery may suffer from poor contact because of dirty or damaged battery contacts; clean the contacts or replace the battery.
What to do if I can't hear anyone because of noise on my POFUNG Transceiver?
If you are unable to hear anyone because of too much noise and hiss on your POFUNG Transceiver, try moving closer to other members. If that doesn't work, move to an open and flat area, restart the radio, and try again. Also, stay away from equipment that may cause interference.
How to fix not communicating with group members on POFUNG Transceiver?
If you cannot communicate with other group members on your POFUNG Transceiver, verify that your TX/RX frequency and signaling type are correct. Also, you may be too far away from other members, so try moving closer.
Why am I hearing unknown voices on my POFUNG Transceiver?
If you hear unknown voices or noise on your POFUNG Transceiver, it may be because you are being interrupted by radios using the same frequency; try changing the frequency or adjusting the squelch level. If your radio is in analog mode, request your dealer to set signaling for the current channel to avoid interference.
What to do if voice is weak on POFUNG Transceiver?
If the voice is weak or intermittent during receiving on your POFUNG Transceiver, recharge or replace the battery, as the battery voltage may be low. Increase the volume. Ensure the antenna is securely attached by turning off the radio, removing, and reattaching the antenna. Also, check if the speaker is blocked and clean it if necessary.
What causes my POFUNG Transceiver to keep transmitting?
If the POFUNG Transceiver keeps transmitting, turn off the VOX function and check that the headphones are correctly installed.
What to do if keys don't work on POFUNG Transceiver?
If you cannot use the keys on your POFUNG Transceiver, restart the radio. The keypad may not work temporarily.
General| Frequency Range | 400-470 MHz |
|---|---|
| Channel Capacity | 16 |
| Number of Channels | 16 |
| Operating Voltage | 7.4 V |
| Output Power | 5W |
| Battery | Li-ion |
Details FCC licensing requirements for using GMRS frequencies in the US.
Specifies spacing for hand-held operation to comply with RF exposure limits.
Outlines RF exposure compliance for body-worn accessories.
Lists unsafe conditions and locations for charging batteries.
Provides guidelines for maintaining battery health and longevity.
Details safety measures for transporting batteries.
Guidance on proper disposal of the product and batteries.
Offers general advice for maintaining the radio and ensuring user safety.
Instructions for the initial and subsequent charging of the Li-ion battery.
Specifies the use of the provided charger for safety and performance.
Advises on safe handling and charging practices for Li-ion batteries.
Step-by-step guide for attaching the belt clip to the radio.
Instructions on how to detach the battery from the radio.
How to turn the radio on/off and adjust the volume level.
Procedures for communicating, including PTT usage and channel selection.
How to use the monitor feature to listen for weak signals.
Enabling and using the channel scanning feature.
How to listen to FM radio stations.
Switching the user interface language between English and Chinese.
Configuring squelch levels for noise suppression.
Using privacy codes for selective communication.
Enabling hands-free transmission via voice activation.
