1110
Installation
Important!
-
For electrical connection carefully follow the
instructions given in the specific paragraphs.
•
Unpack the appliance and check if there is any damage
to it. Do not connect the appliance if it is damaged.
Report possible damages immediately to the place
that you bought it. In that case retain all packing.
•
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow back
in the compressor.
•
Adequate air circulation should be around the
appliance, lacking this leads to overheating. To achieve
sufficient ventilation follow the instructions relevant
to installation.
•
Wherever possible the spacers of the product should
be against a wall to avoid touching or catching warm
parts (compressor, condenser) to prevent possible
burn.
•
The appliance must not be located close to radiators
or cookers.
•
Make sure that the mains power plug is accessible
after the installation of the appliance.
Service
•
Any electrical work required to do the servicing of
the appliance should be carried out by a qualified
electrician or competent person.
To Next Page
Loading...