What to do if my point FS490WNE Freezer is not working?
If your Point Freezer isn't working, first ensure it's properly connected to a power source and that the plug is securely in contact. Also, check if the voltage is sufficient and whether there's a power outage or tripped circuits.
How to get rid of odor in point FS490WNE?
To eliminate odors from your Point Freezer, make sure odorous foods are tightly wrapped. Inspect the freezer for any spoiled food and thoroughly clean the inside.
Why the doors of my point FS490WNE Freezer cannot be properly closed?
If the doors of your Point Freezer aren't closing properly, check for these possible causes: food packages might be obstructing the door, you may have placed too much food inside, or the freezer could be tilted. Adjust the food placement or level the freezer to resolve this.
Why does the compressor of my point FS490WNE operate for a long time?
It's normal for your Point Freezer's compressor to run longer during summer or when the ambient temperature is high. Also, avoid storing too much food at once and ensure food is cooled before placing it inside. Frequent door openings can also cause prolonged operation.
How to reduce loud noise from point FS490WNE?
To reduce loud noises from your Point Freezer, verify that the floor is level and the freezer is placed stably. Also, ensure all accessories are correctly positioned.
What to do if the light is not working in Point Freezer?
If the light in your Point Freezer isn't working, first check if the freezer is connected to a power supply. Also, check whether the illuminating light is damaged. If the light is damaged, have it replaced by a specialist.
How to fix a gasket gap on point FS490WNE?
To fix a gasket gap on your Point Freezer, start by removing any foreign material from the door seal. If the gap persists, heat the door seal and then cool it to restore its shape. You can use an electrical drier or a hot towel for heating.
Why does the water pan overflow in point FS490WNE?
The water pan in your Point Freezer might overflow due to excessive food in the chamber, food with high water content causing heavy defrosting, or doors not closed properly allowing air entry and increased defrosting.
Why is the side wall of my Point Freezer overheating?
The side wall of your Point Freezer may overheat due to heat dissipation from the built-in condenser through the housing, which is normal. If the housing becomes too hot due to high ambient temperature, too much stored food, or compressor shutdown, ensure proper ventilation to facilitate heat dissipation.
How to remove surface condensation on point FS490WNE?
To remove surface condensation on your Point Freezer, simply wipe the condensate with a clean towel.
Explains the various symbols used to convey safety warnings.
Highlights important safety precautions regarding electrical connections and usage.
General warnings and precautions to follow during the operation of the appliance.
Safety advice on what items should not be placed inside or near the appliance.
Instructions and warnings concerning the safe and environmentally sound disposal of the appliance.
Addresses common problems like condensation, noise, odor, and non-working lights.
To Next Page
General